Clifford Bullet Owners Guide - Page 10

User-Selectable Features Your Bullet vehicle security system allows you to set many of its features to your own personal preferences. We have made the programming procedures very simple: to make a change, you just flick the valet switch a few times. The system comes from the factory with all of its features pre-programmed as noted in the table below and on page 10. To change any of the settings, use the procedure noted. To restore the feature to its factory setting, just repeat the procedure: 1. Select the feature you wish to program from the table on the following pages. Note the number of flicks and chirps associated with that feature. 2. Insert your ignition key and turn it to the "ON" position. 3. Immediately flick the valet switch back and forth, counting the number of chirps you hear. Stop when you reach the appropriate number of chirps 4. If noted, do the "secondary action." 5. You will hear one or more chirps (as noted in the "program completion con- firmation" section) to confirm that you have changed the feature setting. Turn the ignition off. 6. Repeat steps 1-5 for any other features you wish to program. Programming Table for User-Selectable Features Feature Factory setting # of flicks & chirps Secondary action Program completion confirmation Result AutoArming ON 4 AutoArm & Lock OFF 5 Arm/Disarm Chirp Confir- ON 6 mation Chirp Full Volume Volume 7 Headlights On Reminder ON 8 AutoLock/ AutoUnLock ON 9 - 1 chirp 3 seconds after last step Change state from ON to OFF or vice-versa - 1 chirp 3 seconds after last step Change state from ON to OFF or vice-versa - 1 chirp 3 seconds after last step Change state from ON to OFF or vice-versa 1 chirp 3 Changes state from - seconds after LOUD to SOFT volume or last step vice-versa - 1 chirp 3 seconds after last step Change state from ON to OFF or vice-versa - 1 chirp 3 seconds after last step Change state from ON to OFF or vice-versa 9