Clifford Bullet Owners Guide - Page 8

FACT™- False Alarm Control and Test, Dual-Mode Tampering Warning, Smart Prior Intrusion Attempt - 4 alarm

Get Clifford Bullet PDF manuals and user guides View all Clifford Bullet manuals
Add to My Manuals
Save this manual to your list of manuals

Page 8 highlights

FACT™- False Alarm Control and Test With FACT, you'll never experience repeated false alarms. If your six-sound siren goes off, DO NOT remotely disarm the system while the siren sounds; allow it to run for the full siren duration. Before sounding the siren a second time, the system automatically checks for another activated trigger. Should the siren sound again, you will know for sure that someone is tampering with your vehicle. (To disable FACT, see User-Selectable Features on pages 9-10.) Dual-Mode Tampering Warning Normally, the system immediately sounds its six-sound siren at the first inkling of an intrusion attempt. However, you may set the system to issue a rapid five-chirp warning whenever the system detects tampering to the exterior of your vehicle. If there is any further tampering within the next 30 seconds, or if a door, the hood or trunk is opened at any time, your system will sound a continuous 125dB six-sound siren blast. To select the mode of your choice, see User-Selectable Features on pages 9-10. NOTE:Turning on the Tampering Warning feature overrides the FACT feature, and vice-versa. Smart Prior Intrusion Attempt Alert When you remotely disarm, if you hear 3 chirps instead of the usual one chirp it means that a trigger or sensor was activated in your absence. When you enter the vehicle, the LED will blink several times, pause, then repeat the blink cycle 4 more times. Count the number of blinks in one cycle and refer to the chart below: Number of LED blinks per cycle after disarming 1 blink 2 blinks 3 blinks Trigger/Sensor Activated Magnetic Resonance Sensor Door trigger Trunk or hood trigger AutoLock/AutoUnLock For your safety and that of your passengers, the system automatically locks the doors when you turn on the ignition switch to start the engine and unlocks them once the ignition is turned off. If you prefer, you may turn off the AutoLock/AutoUnLock feature. See the User-Selectable Features section on pages 9-10. Siren Duration When the system detects an intrusion attempt, the alarm is set to sound for 30 seconds. However, if you prefer, you may change it to 60 seconds. See the User-Selectable Features section on pages 9-10. 7

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
FACT™— False Alarm Control and Test
With FACT, you’ll never experience repeated false alarms. If your six-sound siren
goes off, DO NOT remotely disarm the system while the siren sounds; allow it to
run for the full siren duration. Before sounding the siren a second time, the system
automatically checks for another activated trigger. Should the siren sound again,
you will know for sure
that someone is tampering with your vehicle. (To disable
FACT, see
User-Selectable Features
on pages 9-10.)
Dual-Mode Tampering Warning
Normally, the system immediately sounds its six-sound siren at the first inkling of
an intrusion attempt. However, you may set the system to issue a rapid five-chirp
warning whenever the system detects tampering to the exterior of your vehicle. If
there is any further tampering within the next 30 seconds, or if a door, the hood or
trunk is opened at
any
time, your system will sound a continuous 125dB
six-sound siren blast. To select the mode of your choice, see
User-Selectable
Features
on pages 9-10.
NOTE:Turning on the Tampering Warning feature overrides the FACT fea-
ture, and vice-versa.
Smart Prior Intrusion Attempt Alert
When you remotely disarm, if you hear 3 chirps instead of the usual one chirp it
means that a trigger or sensor was activated in your absence. When you enter the
vehicle, the LED will blink several times, pause, then repeat the blink cycle 4
more times. Count the number of blinks in one cycle and refer to the chart below:
Number of LED blinks per cycle after disarming
Trigger/Sensor Activated
1 blink
Magnetic Resonance Sensor
2 blinks
Door trigger
3 blinks
Trunk or hood trigger
AutoLock/AutoUnLock
For your safety and that of your passengers, the system automatically locks the doors
when you turn on the ignition switch to start the engine and unlocks them once the
ignition is turned off. If you prefer, you may turn off the AutoLock/AutoUnLock
feature. See the
User-Selectable Features
section on pages 9-10.
Siren Duration
When the system detects
an intrusion attempt, the alarm is set to sound for 30
seconds. However, if you prefer, you may change it to 60 seconds. See the
User-Selectable Features
section on pages 9-10.
7