Clifford IntelliGuard 800 Owners Guide - Page 16
not sensitive enough, you may individually test and adjust the sensitivity, settings yourself. To
View all Clifford IntelliGuard 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
not sensitive enough, you may individually test and adjust the sensitivity settings yourself. To do so, just use the following procedure: 1. Disarm the system, open the driver's window, then select the zone you wish: a. Interior zone: Transmit channel 11 (LevelShift twice, then button 3). b.Outer warning zone: Transmit channel 12 (LevelShift twice, then button 4). 2. To test the current sensitivity setting: a. Interior zone: Lean into the passenger compartment. You will hear a chirp when the zone detects your presence. Ideally, it should chirp when you lean over the driver's seat, but remain silent when you lean toward the window. b.Outer zone: Lean toward the driver's window. You will hear a chirp when the zone detects your presence. Ideally, it should chirp only when you are within about one foot of the vehicle. 3. To increase sensitivity, press button 2 on your remote control. To decrease it, press button 4. Each time you increase sensitivity, the siren will chirp in higher and higher pitched tones to confirm the higher sensitivity. Conversely, lower and lower tones confirm each sensitivity decrease. Two normal tone chirps indicate minimum and maximum sensitivity. There are 32 sensitivity levels for the Proximity Sensor's critical inner zone; 16 for the outer warning zone. 4. Repeat steps 2 and 3 until you are satisfied with the sensitivity, then press button 1 to record the new sensitivity setting and exit the sensor test/adjust mode (you'll hear three chirps to confirm exit). You may now either repeat steps 1-4 for the other sensor zone, or press button 1 to arm the system. Sound complicated? It really isn't, there's just a lot of explanation of what's happening with each step. All you really have to do is the actions noted in bold type. Give it a try. FACT™- False Alarm Control and Test With FACT, you'll never experience repeated false alarms. If the siren goes off, DO NOT disarm the system; let it run for the full siren duration. Before sounding the siren a second time, the system automatically checks for another activated trigger to verify that an intrusion is in progress. Should the siren sound again, you will know for sure someone is tampering with your vehicle. Fault-Proof™ starter interrupt While the system is armed, the vehicle's starter circuit is electronically disconnected. Our Fault-Proof design ensures that you'll be able to start the engine even in the unlikely event of a system malfunction. Other, non-Clifford alarms may leave you stranded. Optional tamper-proof ignition immobilization If your IntelliGuard 800 is equipped with the ignition immobilization option, while armed, the system ensures that your vehicle is completely immobilized by automatically locking out the ignition system. That means that a thief won't be able to start your vehicle's engine even if he had a duplicate of your car key. What's more, even if he were to find the system control unit and tear it out of your vehicle, he still won't be able to start your car's engine! That's Clifford security you can count on. 15