Cobra Battery Charger 2A Battery Charger 2A Manual - Page 7

Charging Your Battery Always make sure to check your battery before charging to verify its type and the correct charging mode required. 1. When the charger is first plugged into a suitable electrical outlet it will enter standby mode and the standby power indicator will illuminate orange. 2. Press the mode button to cycle through to the desired charging mode. For 6V and Low Voltage charging modes, press and hold the mode button for two (2) or six (6) seconds depending on which mode you wish to enter. 3. Once the desired charge mode has been selected the LED status light will illuminate (depending on the health of the battery) and begin blinking orange to indicate that charging has started. For a more detailed list on the LED status light readout, refer to the table on the following page. 4. Charging is completed when the LED status light shows a solid green readout. At this point you can either remove the battery charger or leave it connected in order to provide maintenance charging. Verify your battery's voltage and type Select the desired battery voltage and type on the battery charger by pressing the mode button to cycle through 12V Lithium-Ion Charging has begun when the LED status light begins to blink orange When charging is complete (solid green light) you can safely leave the charger connected to maintain a full charge or disconnect and store for future use 6