Compaq Evo n1020v Compaq Evo Notebook N1020v Series, N1000v Series and Compaq - Page 143
Removing the Palm Rest, Release the ZIF connector to which the system board
View all Compaq Evo n1020v manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Removal and Replacement Procedures 6. Turn the computer top side up with the front facing forward. 7. Open the computer. 8. Lift the front edge of the palm rest and swing it up and back 1 until it rests on the top cover (Figure 5-28). 9. Release the ZIF connector to which the diskette drive cable is attached 2 and disconnect the diskette drive cable 3 from the system board. 10. Release the ZIF connector to which the system boardto-TouchButton board cable is attached 4 and disconnect the cable 5 from the TouchButton board. Figure 5-28. Removing the Palm Rest Maintenance and Service Guide 5-37
Removal and Replacement Procedures
Maintenance and Service Guide
5–37
6. Turn the computer top side up with the front facing forward.
7. Open the computer.
8. Lift the front edge of the palm rest and swing it up and
back
1
until it rests on the top cover (Figure 5-28).
9. Release the ZIF connector to which the diskette drive cable
is attached
2
and disconnect the diskette drive cable
3
from
the system board.
10. Release the ZIF connector to which the system board-
to-TouchButton board cable is attached
4
and disconnect
the cable
5
from the TouchButton board.
Figure 5-28. Removing the Palm Rest