Compaq ProSignia 500 SMART-2DH Array Controller Reference Guide - Page 73
Installing the Driver, Latest Drivers
View all Compaq ProSignia 500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
6-5 Installing the Driver The following steps outline the procedure to install the SMART-2DH Controller driver on your NetWare/intraNetWare server. 1. Boot the server. 2. From the DOS prompt, copy the CPQDA386.DSK (version 3.10 or later) or the CPQARRAY.HAM driver file from the \DRV_ARRY directory on the fourth Novell SSD diskette to the primary DOS partition on the boot drive in the server. This is where the NetWare/intraNetWare server files are located, usually drive c: copy A:\drv_arry\cpqda386.dsk C:\nwserver 3. Edit the STARTUP.NCF file so that the driver loads automatically at system startup. With any DOS editor, add the following line: load cpqda386 4. Refer to NetWare/intraNetWare installation documentation for information about installing and mounting volumes associated with your new disk subsystem. Driver installation is complete. If you are using Compaq Insight Manager, see the following section for information on updating the Insight Agents. Latest Drivers The latest drivers for future upgrades may be obtained from the Internet: World Wide Web Go to http://www.compaq.com. CompuServe Enter GO COMPAQ or go directly to the Compaq Forum. America Online Use the navigation keyword COMPAQ. Prodigy Use the JUMP navigation command followed by the keyword COMPAQ. SMART-2DH Array Controller Reference Guide Writer: Pamela King Project: SMART-2DH Array Controller Reference Guide Comments: 295469-002 File Name: G-CH06.DOC Last Saved On: 2/27/98 12:01 PM COMPAQ CONFIDENTIAL - NEED TO KNOW REQUIRED