Compaq d530 HP Compaq Business Desktop d500 Service Reference Guide, 5th Editi - Page 81

Removal and Replacement Procedures- Convertible Minitower (CMT) Chassis 4. Open both latches of the memory module socket 1, and insert the memory module into the socket 2. Begin by installing a module into the socket nearest the preinstalled module, and install the modules following the numerical order of the sockets. ✎ A memory module can be installed in only one way. Match the notch on the module with the tab on the memory socket. 5. Push the module down into the socket, ensuring that the module is fully inserted and properly seated. Make sure the latches are in the closed position 3. 6. Repeat steps 4 and 5 for any additional modules that you want to install. ✎ The computer automatically recognizes the additional memory when the computer is turned on. To reassemble the computer, reverse the removal procedure. ✎ If you normally lock the Smart Cover Lock, use Computer Setup to relock the lock and enable the Smart Cover Sensor. 6.9 Expansion Cards 1. If you have locked the Smart Cover Lock, use Computer Setup to unlock the lock (Section 6.2, "Unlocking the Smart Cover Lock"). 2. Prepare the computer for disassembly (Section 6.1, "Preparation for Disassembly"). 3. Remove the computer access panel (Section 6.5, "Computer Access Panel"). 4. .Locate the correct vacant expansion socket on the system board and the corresponding expansion slot on the back of the computer chassis. Service Reference Guide, d500 336492-005 6-9