Compaq nx6110 HP Compaq nx6110, nc6110, nx6120 and nc6120 Notebook PCs - Maint - Page 155
Remove the Phillips PM1.5×3.0 screw, USB/audio board and shield to the base enclosure.
View all Compaq nx6110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Removal and Replacement Procedures 2. Position the computer with the rear panel toward you. 3. Disconnect the USB cable 1 and audio cable 2 from the system board. ✎ The USB cable is present only on full-featured models. 4. Remove the Phillips PM1.5×3.0 screw 3 that secures the USB/audio board and shield to the base enclosure. 5. Remove the cables from the clips 4 in the base enclosure. 6. Remove the USB/audio board 5. Removing the USB/Audio Board Reverse the above procedure to install the USB/audio board. Maintenance and Service Guide 6-49
Removal and Replacement Procedures
Maintenance and Service Guide
6–49
2. Position the computer with the rear panel toward you.
3. Disconnect the USB cable
1
and audio cable
2
from the
system board.
✎
The USB cable is present only on full-featured models.
4. Remove the Phillips PM1.5×3.0 screw
3
that secures the
USB/audio board and shield to the base enclosure.
5. Remove the cables from the clips
4
in the base enclosure.
6. Remove the USB/audio board
5
.
Removing the USB/Audio Board
Reverse the above procedure to install the USB/audio board.