Compaq nx6110 HP Compaq nx6110, nc6110, nx6120 and nc6120 Notebook PCs - Maint - Page 158
Remove the Torx8 T8M2.0×4.0 screw, Step 4 applies only to full-featured models.
![]() |
View all Compaq nx6110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Removal and Replacement Procedures 2. Disconnect the serial connector cable 1 and the Bluetooth cable 2 from the system board. 3. Remove the Torx8 T8M2.0×4.0 screw 3 that secures the system board to the base enclosure next to the RJ-11 connector. ✎ Step 4 applies only to full-featured models. 4. Remove the 2 HM5.0×9.0 screw locks 4 on each side of the parallel connector. 5. Remove the 2 HM5.0×9.0 screw locks 5 on each side of the external monitor connectors. Removing the System Board Screws and Screw Locks 6-52 Maintenance and Service Guide
![](/manual_guide/products/compaq-nc6110-hp-compaq-nx6110-nc6110-nx6120-nc6120-notebook-pcs-maintenance-service-guide-c08764e/158.png)
6–52
Maintenance and Service Guide
Removal and Replacement Procedures
2. Disconnect the serial connector cable
1
and the Bluetooth
cable
2
from the system board.
3. Remove the Torx8 T8M2.0×4.0 screw
3
that secures the
system board to the base enclosure next to the RJ-11
connector.
✎
Step 4 applies only to full-featured models.
4. Remove the 2 HM5.0×9.0 screw locks
4
on each side of the
parallel connector.
5. Remove the 2 HM5.0×9.0 screw locks
5
on each side of
the external monitor connectors.
Removing the System Board Screws and Screw Locks