Compaq nx6110 HP Compaq nx6110, nc6110, nx6120 and nc6120 Notebook PCs - Maint - Page 194
General Requirements, configuration of an EN 60 320/IEC 320 Standard Sheet C13
![]() |
View all Compaq nx6110 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Power Cord Set Requirements General Requirements The requirements listed below are applicable to all countries. ■ The length of the power cord set must be at least 1.5 m (5.0 ft) and a maximum of 2.0 m (6.5 ft). ■ All power cord sets must be approved by an acceptable accredited agency responsible for evaluation in the country where the power cord set will be used. ■ The power cord sets must have a minimum current capacity of 10 amps and a nominal voltage rating of 125 or 250 V AC, as required by each country's power system. ■ The appliance coupler must meet the mechanical configuration of an EN 60 320/IEC 320 Standard Sheet C13 connector for mating with the appliance inlet on the back of the computer. B-2 Maintenance and Service Guide
![](/manual_guide/products/compaq-nc6110-hp-compaq-nx6110-nc6110-nx6120-nc6120-notebook-pcs-maintenance-service-guide-c08764e/194.png)
B–2
Maintenance and Service Guide
Power Cord Set Requirements
General Requirements
The requirements listed below are applicable to all countries.
■
The length of the power cord set must be at least 1.5 m
(5.0 ft) and a maximum of 2.0 m (6.5 ft).
■
All power cord sets must be approved by an acceptable
accredited agency responsible for evaluation in the
country where the power cord set will be used.
■
The power cord sets must have a minimum current capacity
of 10 amps and a nominal voltage rating of 125 or 250 V AC,
as required by each country’s power system.
■
The appliance coupler must meet the mechanical
configuration of an EN 60 320/IEC 320 Standard Sheet C13
connector for mating with the appliance inlet on the back of
the computer.