Craftsman 020395 Operation Manual - Page 15
Pressure Washer Rinsing, Cleaning Detergent Siphoning Tube, Automatic Cool Down System Thermal
View all Craftsman 020395 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
Pressure Washer Rinsing For Rinsing: 1. Remove black detergent spray tip from spray tip extension. 2. Select and install desired high pressure spray tip following instructions How to Use Spray Tips. 3. Keep spray gun a safe distance from areayou plan to spray. A, WARNING Kickback from spray gun can cause you to fall. • Operatepressurewasherfrom a stablesurface. • Beextremelycarefulif you mustusethe pressurewasherfrom a ladder,scaffolding,or anyothersimilarlocation. • Firmlygraspspraygun with bothhandswhen usinghigh pressuresprayto avoidinjurywhenspraygun kicks back. 4. Apply a high pressure spray to a small area and then check surface for damage. If no damage is found, you can assume it is okay to continue rinsing. 5. Start at top of area to be rinsed, working down with same overlapping strokes as you used for cleaning. Cleaning Detergent Siphoning Tube If you used the clear detergent siphoning tube, you must flush it with clean water before stopping the engine. 1. Place detergent siphoning tube/filter in a bucket full of clean water. 2. Remove high pressure spray tip from spray tip extension. . Select and install black detergent spray tip following instructions How to Use Spray Tips. 4. Flush for 1-2 minutes. 5. Shut off engine following instructions How to Stop Pressure Washerand turn off water supply. 6. ALWAYS point spray gun in a safe direction push red button and squeezespray gun trigger to release retained high water pressure. IMPORTANT:Spray gun traps high water pressure, even when engine is stopped and water is disconnected. A, WARNING The high pressure stream of water that tahnisd eitsquuinpdmeernlytinpgrotdisuscueessc, alenacduint gthtorousegrhiosuksin injury and possible amputation. Spray gun traps high water pressure, even when engine is stopped and water is disconnected, which can cause injury. • Keephigh pressurehoseconnectedto pumpand spraygun whilesystemis pressurized. • ALWAYSpointspraygun in safedirection,pressredbutton andsqueezesprayguntriggerto releasehighpressuree, very time youstop engine. Automatic Cool Down System (Thermal Relief) If you run the engine on your pressure washer for 3-5 minutes without pressing the trigger on the spray gun, circulating water in the pump can reach temperatures above 125°F. The system engages to cool the pump by discharging the warm water ontothe ground. 15