Craftsman 21602 Operation Manual - Page 17

Saw To Work

Get Craftsman 21602 - 16 in. Variable Speed Scroll Saw PDF manuals and user guides View all Craftsman 21602 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 17 highlights

Estimated Assembly Time: 5-10 minutes WARNING J To avoid injury, do not connect this scroll saw to the power source until it is completely assembled and adjusted and you have read and understood this instruction manual. STORING THE T-WRENCH (FIG. B) The left rear side of the body (1) has a U-Shaped clamp holder (2) designed to store the T-wrench (3). Position the shaft of the T-wrench handle into the U-shaped clamp holder as shown. Fig. B MOUNTING SCROLL SAW TO WORK SURFACE (FIG. A) 1. If mounting the scroll saw to a workbench, a solid wood bench is preferred over a plywood board to reduce noise and vibration. 2 2. The hardware to mount this saw is NOT supplied with the saw. The hardware as shown in Fig. A should be used: Fig. A BLADE STORAGE (FIG. C) The blade storage (1) is located on the right rear side of the scroll saw body. The blade storage can conveniently store extra Pin-end and Plain-end blades. Fig. C 1 5 4 _----_ -- 6 1. (3) Hex head bolts; length as required 1 2. (6) Flat washers 3. (1) Foam pad or carpet (optional) 4. (3) Lock washers 5. (3) Hex nuts 6. (3) Jam nuts 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
Estimated Assembly Time: 5-10
minutes
WARNING
J
To avoid
injury,
do not
connect
this
scroll
saw to the power
source
until
it is
completely
assembled
and
adjusted
and you have read and
understood
this
instruction
manual.
MOUNTING
SCROLL
SAW TO WORK
SURFACE
(FIG. A)
1. If mounting
the scroll saw to a
workbench,
a solid wood bench is
preferred over a plywood board to
reduce noise and vibration.
2. The hardware to mount this saw
is NOT supplied with the saw. The
hardware as shown in Fig. A should
be used:
Fig. A
STORING
THE T-WRENCH
(FIG. B)
The left rear side of the body (1) has a
U-Shaped clamp holder (2) designed
to store the T-wrench
(3). Position the
shaft of the T-wrench
handle into the
U-shaped
clamp holder as shown.
Fig. B
2
BLADE STORAGE
(FIG.
C)
The
blade storage (1)
is located on the
right rear side
of the
scroll saw body.
The blade storage can conveniently
store extra Pin-end and Plain-end
blades.
Fig. C
1
5
4
_----_
-- 6
1. (3) Hex head bolts; length as
required
1
2. (6) Flat washers
3. (1) Foam pad or carpet (optional)
4. (3) Lock washers
5. (3) Hex nuts
6. (3) Jam nuts
17