Craftsman 21602 Operation Manual - Page 8

, READ AND UNDERSTAND all safety instructions and operating procedures throughout the manual. , DO NOT OPERATE the Scroll Saw until it is completely assembled and installed according to the instructions. , SHOULD any part of Scroll Saw be missing, damaged, or fail in any way, or any electrical component fail to perform properly, shut off the switch and remove the plug from the power supply outlet. Replace missing, damaged, or failed parts before resuming operation. , YOUR SCROLL SAW MUST BE SECURELY FASTENED to a stand or workbench. If there is any tendency for the stand or workbench to move during operation, the stand or workbench MUST be fastened to the floor. , THIS SCROLL SAW is intended for indoor use only. , TENSION BLADE PROPERLY before starting the saw. Recheck and adjust tension as needed. 10. BLADE TEETH MUST POINT downward toward the table. , IF YOU ARE NOT thoroughly familiar with the operation of a Scroll Saw, obtain advice from your supervisor, instructor or other qualified person. 11. TABLE MUST BE CLEARED of all debris before operating saw. Do not perform lay out, set up or assemble work on the table when the saw is in operation. , SERIOUS INJURY could occur if the tool tips over or you accidentally hit the cutting tool. Do not store anything above or near the tool. , AVOID INJURY from unexpected saw movement. Place the saw on a firm level surface where the saw does not rock and bolt or clamp the saw to its support. 12. TO PREVENT INJURIES, avoid awkward hand or finger positions, where a sudden slip could cause a hand to move into the blade when operating the saw. 13. HOLD WORKPIECE FIRMLY against the table top. 14. NEVER CUT MATERIAL that is too small to be held safely.