Craftsman 21914 Operation Manual - Page 5

[] KEEPBiTSCLEANANDSHARPS. harpbitsminimize stallingD. irtyanddullbitsmaycausemisalignmenotf the materiaal ndpossibleoperatorinjury. [] KEEPHANDSAWAYFROMWORKAREA.Keep handsawayfromthe bit.Restrainanylooseclothing, jewelryl,onghair,etc.,thatmaybecomeentangledin the bit. [] ALWAYSCLAMPWORKPIECAENDBRACE AGAINSTCOLUMNTOPREVENTROTATIONN.ever useyourhandto holdtheobjectwhiledrilling. [] USE RECOMMENDED SPEED FOR DRILL ACCESSORY AND WORKPIECE MATERIAL. [] BE SURE DRILL BiT OR CUTTING TOOL iS SECURELY LOCKED iN THE CHUCK, [] BE SURE CHUCK KEY iS REMOVED from the chuck before connecting to power source or turning power ON. [] ADJUST THE TABLE OR DEPTH STOP TO AVOID DRiLLiNG iNTO THE TABLE. Shut off the power, remove the drill bit, and clean the table before leaving machine. [] ALWAYS ENSURE THE LASER BEAM iS AIMED AT A SURFACE WITHOUT REFLECTIVE PROPERTIES. Shiny reflective materials are not suitable for laser use. [] AVOID DIRECT EYE EXPOSURE when using the laser guide. [] NEVER PLACE YOUR FINGERS iN A POSiTiON WHERE THEY COULD CONTACT THE DRILL or other cutting tool if the workpiece should unexpectedly shift. [] NEVER PERFORM ANY OPERATION by moving the head or table with respect to one another. Do not turn the motor switch ON or start any operation before checking that the head and table support lock handle is clamped tight to column and head and table support collars are correctly positioned. [] BEFORE ENGAGING THE POWER SWITCH, MAKE SURE THE BELT GUARD iS DOWN AND THE CHUCK iS iNSTALLED PROPERLY. [] LOCK THE MOTOR SWITCH OFF WHEN LEAVING THE DRILL PRESS. Do not perform layout, assembly, or set-up work on the table while the cutting tool is rotating, switched on, or connected to a power source. [] iF THE POWER SUPPLY CORD iS DAMAGED, it must be replaced only by the manufacturer or by an authorized service center to avoid risk. [] SAVE THESE iNSTRUCTiONS. Refer to them fre- quently and use to instruct other users. If you loan someone this tool, loan them these instructions also. _ WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction activities contains chemicals known to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are: • lead from lead-based paints, crystalline silica from bricks and cement and other masonry products, and arsenic and chromium from chemically-treated lumber. Your risk from these exposures varies, depending on how often you do this type of work. To reduce your exposure to these chemicals: work in a well ventilated area, and work with approved safety equipment, such as those dust masks that are specially designed to filter out microscopic particles.