Craftsman 28908 Operation Manual - Page 27
TROUBLESHOOTING, in, unless directed, Sears service center
View all Craftsman 28908 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
TROUBLESHOOTING CHART: See appropriate section in manual unless directed to Sears service center PROBLEM CAUSE CORRECTION Will not start Hard to start Engine will not turn over Engine clicks but will not start 1 Out of fuel. 2 Engine not "CHOKED" properly. 3 Engine flooded. 4 Bad spark plug. 5 Dirty air filter. 6 Dirty fuel filter. 7 Water in fuel. 8 Loose or damaged wiring. 9 Carburetor out of adjustment. 10 Engine valves out of adjustment. 1 Dirty air filter. 2 Bad spark plug. 3 Weak or dead battery. 4 Dirty fuel filter. 5 Stale or dirty fuel. 6 Loose or damaged wiring. 7 Carburetor out of adjustment. 8 Engine valves out of adjustment. 1 Brake pedal not depressed. 2 Attachment clutch is engaged. 3 Weak or dead battery. 4 Blown fuse. 5 Corroded battery terminals. 6 Loose or damaged wiring. 7 Faulty ignition switch. 8 Faulty solenoid or starter. 9 Faulty operator presence switch(es). 1 Weak or dead battery. 2 Corroded battery terminals. 3 Loose or damaged wiring. 4 Faulty solenoid or starter. 1 Fill fuel tank. 2 See"TO START ENGINE" in Operation section. 3 Wait several minutes before attempting to start. 4 Replace spark plug. 5 Clean/replace air filter. 6 Replace fuel filter. 7 Empty fuel tank and carburetor, refill tank with fresh gasoline and replace fuel filter. 8 Check all wiring. 9 See "To Adjust Carburetor" in Service and Adjustments section. 10 Contact a Sears or other qualified service center. 1 Clean/replace air filter. 2 Replace spark plug. 3 Recharge or replace battery. 4 Replace fuel filter. 5 Empty fuel tank and refill tank with fresh, clean gasoline. 6 Check all wiring. 7 See "To Adjust Carburetor" in Service and Adjustments section. 8 Contact a Sears or other qualified service center. 1 Depress brake pedal. 2 Disengage attachment clutch. 3 Recharge or replace battery. 4 Replace fuse. 5 Clean battery terminals. 6 Check all wiring. 7 Check/replace 8 Check/replace ignition switch. solenoid or starter. 9 Contact a Sears or other qualified service center. 1 Recharge or replace battery. 2 Clean battery terminals. 3 Check all wiring. 4 Check/replace solenoid or starter. 27