Craftsman 28947 Operation Manual - Page 15
TO USE THROTTLE, less than
View all Craftsman 28947 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles. HOW TO USE YOUR TRACTOR TO SET PARKING BRAKE Your tractor is equipped with an operator presence sensing switch, When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine. 1. Depress brake pedal (B) allthe way down and hold. 2. Pull parking brake lever (C) up and hold, release pressure from brake pedal (B), then release parking brake lever. Pedal should remain in brake position. Make sure parking brake will hold tractor secure. ENGINE - • Move throttle control (D) between half and full speed (fast) position. NOTE: Failure to move throttle control between half and full speed (fast) position, before stopping, may cause engine to "backfire". • Turn ignition key (F) to "STOP" position and remove key. Always remove keywhen leaving tractorto prevent unauthorized use. , Never use choke (N) to stop engine° IMPORTANT: Leaving the ignition switch in any position other than "STOP" will cause the battery to discharge and go dead. NOTE: Undercertain conditionswhen tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate this possibility, always stop engine when stopping tractor on grass areas° STOPPING MOWER BLADES - To stop mower blades, move attachment clutch clutch lever to disengaged position CAUTION: Always stop tractor completely, as described above, before leaving the operator's position. TO USE THROTTLE CONTROL (D) Always operate engine at full speed (fast). ° Operating engine at less than full speed (fast) reduces engine's operatingefficiency. • Full speed (fast) offers the best mower performance. (r_t) Attachment Clutch Switch "Engaged" (t_'t)Attachment Clutch Switch "Disengaged" GROUND DRIVE - - To stop ground drive, depress brake pedal all the way down_ IMPORTANT: Forward and reverse drive pedals return to neutral position when not depressed. TO USE CHOKE CONTROL (N) Use choke control whenever you are starting a cold engine_ Do not use to start a warm engine. ° To engage choke control, pull knob out. Slowly push knob in to disengage° 15