Creative 70SB112200000 User Guide - Page 11

Press the Connect button on your transmitter again

10

Step 3: Press the Connect button on your transmitter again

The transmitter’s Link LED flashes. Refer to the diagram in Step 1.

Step 4: Press the Connect button on your second receiver

Refer to the diagram in Step 2. Once the transmitter and receiver are paired

successfully, the Link LED on both units light up green and remain on. Repeat

the steps to pair your third and fourth receivers (if applicable) manually.

Step 5: Test your receivers

1

Play music from your transmitter.

2

Use the transmitter software to select the zones assigned to the receivers

you want to activate or deactivate. See “Using Your Wireless Features” on

page 11 for instructions do this.

NOTE

For troubleshooting information, see “Troubleshooting” on

page 16.

Section	Page
About Your Receiver	3
About Your Remote Control	4
Setting Up Your Receiver	5
Step 1: Position your receiver	5
Step 2: Connect your receiver	5
Step 3: Enable wireless control for your transmitter	6
Step 4: Turn on your receiver and Auto Pair	7
Step 5: Play and stream music from transmitter	8
Setting Up Two or More Receivers	8
Manual Pairing	9
Step 1: Press the Connect button on your transmitter	9
Step 2: Press the Connect button on your first receiver	10
Step 3: Press the Connect button on your transmitter again	11
Step 4: Press the Connect button on your second receiver	11
Step 5: Test your receivers	11
Using Your Wireless Features	12
Other Information	15
Troubleshooting	17
General Specifications	21
Safety Information	22
Declaration of Conformity	25

Creative 70SB112200000 User Guide - Page 11

Step 3: Press the Connect button on your transmitter again, Step 5: Test your receivers

Page 11 highlights