Cub Cadet 221 LHP 221 LHP Operator's Manual - Page 7
Assembly & Set-Up - engine manual
View all Cub Cadet 221 LHP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Assembly & Set-Up 3 Contents of Carton • One Snow Thrower • • Two Ignition Keys • • One Snow Thrower Operator's Manual • One Chute Assembly One 20 oz. Bottle 5W-30 Oil One Engine Operator's Manual • One Chute Rotation Control Assembly • One Electric Starter Cord (If equipped) NOTE: This Operator's Manual covers several models. Snow thrower features may vary by model. Not all features in this manual are applicable to all snow thrower models and the snow thrower depicted may differ from yours. NOTE: All references to the left or right side of the snow thrower are from the operator's position. Any exceptions will be noted. Unpacking the Snow Thrower 1. Open the top of the carton. 2. Cut down the corners on the front of the carton and fold down the front side. 3. Pull the snow thrower out of the carton. Be sure not to damage the chute, chute rotation control assembly or any cables attached to the chute. Some of these parts are shipped under the shroud on the backside of the carton. Check for any cable ties securing the chute and remove if necessary. Set-Up Adding Fuel & Oil Refer to the Engine Operator's Manual packed with your snow thrower for information on adding fuel and oil. Assembly Positioning the Upper Handle 1. Remove the wing knob and carriage bolt from the top of the lower handle. See Figure 3-1. It is not necessary to remove the shoulder screw and flange lock nut below the wing knob and carriage bolt. Wing Knob Carriage Bolts Wing Knob Figure 3-1 7