Cub Cadet 221 LHP 221 LHP Operator's Manual - Page 8
Installing the Chute - 221
View all Cub Cadet 221 LHP manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 8 highlights
2. Pivot the upper handle into the operating position. Be sure Installing the Chute not to pinch any of the cables in the process. See Figure 3-2. 1. On the 221 HP model place the chute handle on the lower chute as shown in Figure 3-4. Skip to step 2 for 221 LHP models. Be certain that the handle is aligned in the channel on the chute and the tabs snap into place. Wing Knob Carriage Bolts Channel Wing Knob Figure 3-2 3. On model 221 HP, tighten the previously removed hardware to secure the handle in place. See Figure 3-2. On model 221 LHP proceed with step 4. Tab Figure 3-4 4. The handle on model 221 LHP can be set in three different 2. Remove the hex washer screws in the chute base. See position. Place the handle in the desired position and then Figure 3-5. install wing knobs and carriage bolts in the appropriate hole and secure the handle. See Figure 3-3. Carriage Bolt Hex Washer Screw Wing Knob Figure 3-3 Figure 3-5 8 Section 3- Assembly & Set-Up