Cub Cadet TANK SZ 60 TANK SZ 48 Operator's Manual - Page 11

Assembly & Set-Up 3 Contents of Crate • One Zero-Turn Tractor • One Deck Wash Hose Coupler • One ROPS Assembly • One Steering Wheel • One Zero-Turn Tractor Operator's • One Engine Operator's Manual Manual NOTE: All references in this manual to the left or right side and 3. front or back of the machine are from the operating position only. Exceptions, if any, will be specified. TOOLS NEEDED: Safety glasses, leather gloves, wire cutters. 4. 1. Remove the upper crating material from the shipping pallet, and cut any bands or tie straps securing the machine to the pallet. 2. Use the deck lift pedal to raise the deck to its highest position and secure in place with the clevis pin attached to the machine. See Fig. 3-1. The two hydrostatic transmissions are equipped with a bypass valve that will allow you to manually move the machine short distances. Engage the transmission bypass valves on each side of the machine by moving both levers to the left. The transmission bypass valves (one for each the RH and LH transmission) are located under the machine on the front of each transmission inside the rear wheels. See Fig. 3-2. Deck Lift Pedal Clevis Pin Figure 3-1 Figure 3-2 WARNING! Do not tow the machine, even with the bypass valves engaged. Serious transmission damage will result from doing so. 5. Then carefully roll the machine off the shipping pallet. 6. Rotate the levers to the right of the machine to disengage the transmission bypass valves. 7. Remove the deck wash system nozzle adapter from the manual bag and store for future use. Cut the wire tie holding the chute deflector up and discard any packing material. 11