Cub Cadet TANK SZ 60 TANK SZ 48 Operator's Manual - Page 18
Transmission Oil Expansion Reservoir Not Shown
View all Cub Cadet TANK SZ 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
4.25" 3.25" 2.25" 1.25" 4.50" 3.50" 2.50" 1.50" 4.75" 3.75" 2.75" 1.75" 5" 4" 3" 2" 1" Deck Height Index The deck height index consists of several holes located on the left of the foot platform. Each hole corresponds to a 1⁄4" change in the deck height position ranging from 1" at the lowest notch to 5" at the highest notch. Deck Lift Pedal The deck lift pedal is located on the left front corner of the foot platform, and is used to raise and lower the mower deck. To raise the mowing deck to the transport position, push the pedal all the way forward until the deck lock rod snaps into position. To remove the deck from the transport position push forward on the deck lift pedal and pull up on the deck lock rod. To position the deck push the pedal all the way forward, remove the clevis pin and reinsert it in the desired cutting height and slowly release pressure on the pedal until you reach the clevis pin. Deck Lift Release Lever The deck lift release lever is located on the left side of the operator's seat and is used to lock the deck in the transport position. Press down on the deck lift pedal and lift up on the deck lift release lever to release the deck. Transmission Oil Expansion Reservoir (Not Shown) The transmission oil expansion reservoir is connected by hoses to the RH and LH transmission assemblies, and is located under the seat. The function of the reservoir is to hold the natural expansion of transmission oil that occurs as the transmission warms up during operation. DO NOT FILL THE RESERVOIR. Under normal operating conditions, no oil should be added to the reservoir. The COLD oil level should be no higher than approximately 1⁄4" above the bottom of the reservoir. NOTE: Prior to the initial operation of the tractor, the oil level in the reservoir may be slightly higher than the maximum due to air in the oil lines. Operation of the tractor will eventually purge the air from the lines and the oil level will settle to the maximum. Steering Column Adjustment Lever Fuel Gauge There is a fuel gauge on top of each of the two fuel tanks and measures the fuel level in each tank. Fuel Valve (Not Shown) The fuel valve is located behind the seat on the right side of the frame. OFF RIGHT FUEL TANK The valve switches the fuel flow from the right and left tank and also L R can shut of fuel flow to the engine. LEFT Rotate the valve to the right to open FUEL the flow from the right fuel tank. TANK I23655 Rotate the valve to the left to open the flow from the left tank. To shut off fuel from both tanks rotate the valve 90° towards the front of the tractor. See the Operation section for more information on using the fuel valve. Accessory Switch Receptacles The three receptacles for AUX. optional accessories are on the RH console. See the Attachments & Accessories section for information. The receptacles are for switches for an optional electric deck lift, lights and/or an auxiliary switch. LIGHTS DECK LIFT Tool Box The tool box is located on the right side of the tractor between the seat and the console. Auxiliary Power Point (Not Shown) The auxiliary power point is a 12V DC outlet and is located inside the toolbox on the right side of the seat. NOTE: Power outlets are designed for accessory plugs only. Do not insert any other object in the power outlet as this will damage the outlet and blow the fuse. Do not hang any type of accessory or accessory bracket from the plug. Improper use of the power outlet can cause damage not covered by your warranty. Do not use the power point for operating a cigarette lighter element. The steering column adjustment lever is located on the right side of the steering column. To adjust the angle of the steering column rotate the lever down, move the steering column to the desired position and then rotate the lever up to lock it into position. NOTE: Be sure that the steering column adjustment lever is tight to prevent the column from moving when operating the tractor. 18 Section 4- Controls & Features