Cub Cadet TANK SZ 60 TANK SZ 48 Operator's Manual - Page 29
Deck Wash System, Tractor Storage
View all Cub Cadet TANK SZ 60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
Deck Wash System WARNING! When using the deck wash system, never engage the deck from any position other than the operator's seat of the tractor. Do not use an assistant or engage deck in the presence of any bystanders. Use the Deck Wash System to rinse grass clippings from the deck's underside and prevent the buildup of corrosive chemicals. Complete the following steps after each mowing: NOTE: Make certain the machine's discharge chute is directed away from people, children, animals, and your house, garage, parked cars, etc. 1. Attach the nozzle adapter to a standard garden hose connected to a water supply. 2. Move the tractor to an area within reach of the hose where you won't have a problem with wet grass clippings. Disengage the PTO, engage the parking brake, and stop the engine. 3. Pull back the lock collar of the nozzle adapter and push the adapter onto one of the deck wash nozzles at either end of the mower deck. Release the lock collar to lock the adapter on the nozzle. See Fig. 6-2. Tractor Storage If your tractor is not going to be operated for an extended period of time (thirty days to approximately six months), the tractor should be prepared for storage. Store the tractor in a dry and protected location. If stored outside, cover the tractor (including the tires) to protect it from the elements. The procedures outlined below should be performed whenever the tractor is placed in storage. 1. Change the engine oil and filter following the instructions provided in the engine manual. WARNING! Never store the tractor with fuel in the tank indoors or in poorly ventilated enclosures, where fuel fumes may reach an open flame, spark or pilot light as on a furnace, water heater, clothes dryer, etc. 2. If storing the tractor for 30 days or more: a. To prevent gum deposits from forming inside the engine's carburetor and causing possible malfunction of the engine, the fuel system must be either completely emptied, or the gasoline must be treated with a stabilizer to prevent deterioration. WARNING! Fuel left in the fuel tank deteriorates and will cause serious starting problems. b. Using a fuel stabilizer: • Read the product manufacturer's instructions and recommendations. • Add to clean, fresh gasoline the correct amount of stabilizer for the capacity (approximately 3 gallons) of the fuel system. • Fill the fuel tank with treated fuel and run the engine for 2-3 minutes to get stabilized fuel into the carburetor. c. Emptying the fuel system: • Prior to putting the tractor in storage, monitor fuel consumption with the goal of running Figure 6-2 the fuel tank empty. 4. Turn on the water supply. 5. From the tractor operator's seat, start the engine and engage the PTO. Allow to run as needed. Disengage the PTO and stop the engine. 6. Turn off the water supply. • Close the fuel valve. Disconnect the fuel line from the carburetor and put the end into an approved fuel container. • Open the fuel valve and drain the fuel tank and line into the approved container. Reinstall the fuel line on the carburetor. 7. Pull back the lock collar of the nozzle adapter to disconnect the adapter from the nozzle. • Start the engine and allow it to run out of fuel. This will prevent gum and varnish deposits 8. Repeat the previous steps to clean the deck using the from forming. Replace the fuel filter. nozzle at the other end of the deck. 3. Remove the spark plugs and pour approximately one ounce of oil into each cylinder. Crank the engine one or two turns to spread the oil evenly on the cylinder walls. Replace the spark plugs. 4. Clean the engine and the entire tractor thoroughly. NOTE: Use of a pressure washer or garden hose is not recommended to clean your tractor. This may cause damage to electrical components, spindles, pulleys, bearings or the engine. The use of water will result in shortened life and reduce serviceability. Section 6 - Maintenance & Adjustments 29