Cub Cadet ZT1 42E Operation Manual - Page 9
Assembly
View all Cub Cadet ZT1 42E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 9 highlights
ASSEMBLY NOTE: Reference to right and left hand side of the tractor is observed from the operating position. NOTE: Some components may come already assembled. If they are already assembled, skip ahead to the next step. Manually Moving the Tractor CAUTION Never tow your tractor. Towing the tractor with the rear wheels on the ground may cause severe damage to the drive motors. The tractor can be moved as long as the parking brake is not set. The tractor can be pushed slowly. Install Hitch (If Necessary) 1. Locate Hitch (a) and install on the rear of the frame using the two hex washer screws (b) provided (Figure 1). NOTE: Hitch and hex washer screws will be in the hardware pack. Install Operator's Seat KNOB ADJUST OR LEVER ADJUST 1. Cut any straps securing the seat assembly to the tractor. Remove all packing material. NOTE: Be careful not to cut the seat wiring harness. 2. Install the seat onto the seat pan (a) using hardware provided. • For a Knob Adjust seat: insert bolts (b) in the rear holes and lock washer (c) and knobs (d) in the front. Tighten securely (Figure 3). • For a Lever Adjust seat: use flange lock nuts (a) and flat washers (b) (Figure 4). a b b a Figure 1 Reposition Upper Hoop (If necessary) The upper hoop may be positioned down for shipping purposes: 1. Remove the two hex washer screws (a) partially installed on the frame (Figure 2). 2. Rotate the upper hoop (b) into position (Figure 2). 3. Secure hoop in place with the hex washer screws removed in step 1. Torque the hex washer screws to 179-219 in-lbs (20-25 N-m). b b c d c d Figure 3 b b a a a b a c Figure 4 a Figure 2 9