Cuisinart CBT 700 CBT-700 Manual - Page 7

7

b)

Ice Crush:

From the Standby mode, press Ice Crush. A pre-pro-

grammed cycle will begin. It is designed to run for a 35-second cycle

and will automatically stop at that point and an audible chime will

sound. The blender will then go into standby mode. To start another

cycle, press Ice Crush again. To interrupt the program, press Ice Crush

and the unit will pause, reverting to Standby. To continue, press Ice

Crush again. To stop the cycle, move to another setting or press On/

Off.

Note:

We recommend you use approximately 8 cubes per cycle.

9.

To Dislodge Food:

Use a rubber or plastic spatula to help remove

food lodged around the cutting assembly.

DO NOT USE SPATULA

UNTIL YOU HAVE TURNED THE BLENDER OFF.

Replace the cover

and measured pour lid and continue blending, if necessary. Make sure

spatula is not inside the blender jar before blending.

10.

When Finished Blending:

Press the On/Off button and unplug the

blender from the electrical outlet. Never remove the blender jar from

the motor base until the blender is off. Do not twist locking ring from

blender jar when removing jar from motor base. Simply lift blender jar

from motor base.

Do not put hands into blender jar with blender

plugged in.

CLEANING AND MAINTENANCE

Always unplug your Cuisinart

®

PowerEdge

®

700-Watt Blender

from the electrical outlet before cleaning. The blender is made of

corrosion-resistant parts that are easy to clean. Before first use and

after every use, clean each part thoroughly. Periodically check all parts

before reassembly. If any part is damaged or blender jar is chipped or

cracked, DO NOT USE BLENDER.

Remove the blender jar from the motor base by lifting straight up and away.

Invert the jar. Twist off the locking ring by turning counterclockwise.

Remove the cutting assembly and rubber gasket. Wash in warm soapy

water; rinse and dry thoroughly.

Place the locking ring in the upper rack of the dishwasher or wash in

warm water.

CAUTION:

Handle the cutting assembly carefully. It is SHARP and may

cause injury. Do not attempt to remove blades from cutting assembly.

Remove the blender jar cover and the measured pour lid. Wash in warm,

soapy water; rinse and dry thoroughly, or place in upper rack of dishwasher.

The blender jar must be washed in warm, soapy water and rinsed and dried

thoroughly. The blender jar can also be placed upside down in dishwasher.

Finally, wipe the motor base clean with a damp cloth to remove any residue,

and dry thoroughly. Never submerge the motor base in water or other liquid,

or place in a dishwasher.

Tip:

You may wish to clean your blender cutting assembly as follows:

Squirt a small amount of dishwashing liquid into assembled blender jar

and fill halfway with warm water. Run on Low for 15 seconds. Repeat, using

clean tap water. Empty blender jar and carefully disassemble parts. Wash

cutting assembly, gasket and locking ring in warm, soapy water. Rinse and

dry all parts thoroughly. Any other servicing should be performed by an

DOs and DON’Ts WHEN USING YOUR BLENDER

Do:

on the bottom of the blender motor base.

Always add liquid ingredients to the blender jar first, then add

remaining ingredients. This will ensure that ingredients are

uniformly mixed.

1 inch (2.5 cm) to achieve a more uniform result. Cut all cheeses

Cuisinart CBT 700 CBT-700 Manual - Page 7

Cleaning And Maintenance, Dos And Don'ts When Using Your Blender - blender poweredge

Page 7 highlights