D-Link DCS-910 Product Manual - Page 9

Hardware Installation - d link setup

Get D-Link DCS-910 - SECURICAM 10/100 Fast Ethernet Internet Camera Network PDF manuals and user guides
UPC - 790069313776
View all D-Link DCS-910 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 9 highlights

Section 1 - Product Overview Hardware Installation Attach the Antenna* Locate the antenna included with your DCS-920 and attach it to the antenna connector located on the back of the DCS-920. Note: It is required that an Ethernet cable is used during initial setup. Once your wireless configuration is set, you may disconnect the Ethernet cable and begin communicating wirelessly with your DCS-920. Attach the Swivel Stand Locate the stand mount on the back panel of the DCS-910/920 and screw on the swivel stand to the DCS-910/920. Connect the Ethernet Cable Connect the included Ethernet cable to the network cable connector located on the bottom panel of the DCS-910/920 and attach it to the network. Network Connectivity is confirmed when the green LED Indicator on the DCS-910/920, located below the Power LED, is illuminated. * Wireless Antenna is provided with the DCS-920 only. D-Link DCS-910/920 User Manual 

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
9
D-Link DCS-910/9±0 User Manual
Section 1 - Product Overview
Hardware Installation
Note:
It is required that an Ethernet cable is used during initial setup. Once your
wireless configuration is set, you may disconnect the Ethernet cable and begin
communicating wirelessly with your DCS-920.
Connect the Ethernet Cable
Connect the included Ethernet cable to the network cable connector located on the
bottom panel of the DCS-910/920 and attach it to the network. Network Connectivity is
confirmed when the green LED Indicator on the DCS-910/920, located below the Power
LED, is illuminated.
Attach the Swivel Stand
Locate the stand mount on the back panel of the DCS-910/920 and screw on the swivel
stand to the DCS-910/920.
Attach the Antenna*
Locate the antenna included with your DCS-920 and attach it to the antenna connector
located on the back of the DCS-920.
* Wireless Antenna is provided with the DCS-920 only.