D-Link DES-818 User Guide - Page 13

10/100 Fast Ethernet Switch User's Guide in the same configuration. Please note that the punch-down blocks in the wiring closet must also be Category 5 certified. If these blocks do not meet the standard, an upgrade is necessary. Topology A Fast Ethernet workgroup is configured in a star topology and is built around a maximum of two repeaters. Each workgroup forms a separate LAN (also known as a segment or collision domain), and these workgroups can be easily interconnected through switches, bridges, or routers to form one LAN large enough to encompass a high-rise building or campus environment. Recent innovations in LAN hub technology such as stackable hubs, coupled with the decreasing cost of switches, bridges, and routers, allow the design of low-cost, efficient Fast Ethernet workgroups and enterprise LANs. The following factors strongly influence the architecture of Fast Ethernet networks: • The EIA/TIA 568 Wiring Standard imposes a 100 meter limit on horizontal runs of twisted-pair cables; that is, connections from the wiring closet to the end-station. • Fast Ethernet's increased operational speed reduces the maximum distance between all elements of the LAN (see below). • The EIA/TIA 568 Wiring Standard does not support the use of coaxial cables for horizontal wiring. Network Network diameter, which is the distance between two end-stations in the same collision domain, is the primary difference between traditional Ethernet and Fast Ethernet. Due to the increased speed in Fast Ethernet and adherence to the EIA/TIA 568 wiring rules, the network diameter of a Fast Ethernet collision domain is limited to 205 meters; in contrast, the maximum 10BASE-T Ethernet collision domain diameter can be up to 2500 meters. Overview 3