D-Link DFL-2560G Hardware Installation Guide - Page 7

2. A RS-232 cable with female DB-9 connector. (included in the package) 3. If your Laptop or PC doesn't have RS-232 connector, an adapter is required. Note: DFL-2560/2560G does not come with an RS-232 adapter. To establish a console connection: 1. Plug the female end of the supplied RS-232 cable directly to the console port on the Firewall, and tighten the captive retaining screws. 2. Connect the other end of the cable to a terminal or to the serial connector of a computer running terminal emulation software. Use the following settings for terminal emulation software: Baud rate: 9600 Data bits: 8 Parity: None Stop bits: 1 Flow control: None 3. Once you have correctly set up the terminal, switch on your device. A boot sequence will appear on the terminal screen. 4. Once the boot sequence completes, the command prompt is displayed, the device is ready to be configured. Finalizing the Configuration After initial setup, please refer to the companion publications found in PDF format on the accompanying Reference CD for detailed instructions on configuring the DFL-2560/2560G. D-Link NetDefend Firewall Log Reference Guide This document describes all log messages that might be generated by the NetDefendOS. D-Link NetDefend Firewall CLI Reference Guide This document describes all available textbased commands that can be used with the RS232 Console or SSH interface to configure the firewall. Additional Information In addition to the user manual, the Reference CD also includes many device configuration examples. Additional help is available through D-Link worldwide offices listed in the appendix of the User Manual or online. To learn more about D-Link security product products, please visit the website http://security.dlink.com.tw. For support, please visit the website http://support.dlink.com.tw, which will redirect you to your regional D-Link website. Technical Support United Kingdom (Mon-Fri) website: http://www.dlink.co.uk FTP: ftp://ftp.dlink.co.uk Home Wireless/Broadband 0871 873 3000 (9.00am-06.00pm, Sat 10.00am-02.00pm) Managed, Smart, & Wireless Switches, or Firewalls 0871 873 0909 (09.00am- 05.30pm) (BT 10ppm, other carriers may vary.) Ireland (Mon-Fri) All Products 1890 886 899 (09.00am-06.00pm, Sat 10.00am-02.00pm) Phone rates: €0.05ppm peak, €0.045ppm off peak times D-Link NetDefend Firewall User Manual This document describes the general operation and control of the NetDefendOS firmware, D-Link's proprietary operating system that drives and controls the NetDefend firewall. The User Manual includes detailed instructions regarding typical administrative tasks. D-Link NetDefend Firewall  7