D-Link DGS-3100-48 Product Manual - Page 245
Up/Download - 24 fan
UPC - 790069304866
View all D-Link DGS-3100-48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 245 highlights
DGS-3100 Series Gigabit Stackable Managed Switch User Manual ID SEVERITY CATEGORY SYSLG1.3.2 SYSLG1.5.23 SYSLG1.5.24 SYSLG1.5.25 SYSLG1.5.26 SYSLG1.5.28 SYSLG1.5.29 SYSLG1.5.30 Information al System Information al Information al Interface Stack Information al Information al Information al Information al Stack Stack IP Information al Stack SYSLG1.6.11 SYSLG1.6.8 Information al Information al System SYSLG4.10.13 SYSLG4.15.16 Information al Information al SYSLG4.15.18 Information al Interface SYSLG4.18.2 SYSLG4.6.9 SYSLG5.3.11 SYSLG6.0.2 Information al Information al Information al Information Security Up/Download MESSAGE threshold.@ DESCRIPTION threshold. PSE power usage %(1)d The PSE power used by the in unit %(2)d is below the specified unit is below the threshold.@ threshold. Unit %(1)d was shutdown The specified unit is - JUMBO frames not shutdown because Jumbo supported. frames are not supported. Master switchover: unit %(1)d is now master. The specified unit is now the Master unit. Backup master unit %(1)d The specified backup was removed from the master is removed from the stack. stack. Unit %(1)d was removed The specified unit is from the stack. removed from the stack. Ipc connection with unit %(1)d failed. The IPC connection with the specified unit has failed. Configuration changed: %(1)s Stack cable %(1)s : link %(2)s on unit-%(3)d The specified stacking cable is connected to the specified unit. PS# %(1)d status changed - %(2)s. The system uses two power supply sources: #1 and #2. The system can operate with one or both power supply units. The power supply has changed. FAN# %(1)d status changed - %(2)s. The specified fan status has changed. Add dynamic MAC %(1)m - Vlan %(2)d failed, %(3)d mac failed to be inserted from the last trap %(1)s %(2)s port %(3)s Media changed from %(1)s to %(2)s on port %(3)s. Shaper cannot be applied on port %(1)s since it's working in half duplex. It will be applied when the port changes to full duplex.@ %(1)s of port %(3)j differ from %(1)s of %(4)j Activating service %(1)d... Boot image download There has been a media change on the specified port. Shaper cannot be applied on the specified port because it is working in half duplex. It will be applied when the port changes to full duplex. The system supports the 229