D-Link DGS-3620-52P Web UI Reference Guide - Page 252

xStack® DGS-3620 Series Layer 3 Managed Stackable Gigabit Switch Web UI Reference Guide Hold Time (0-65535) The system will declare a peer as dead if not receiving a keepalive message until the hold time. If two routers, that built a BGP connection, have different hold times, the smaller hold time will be used. The valid value is from 0 to 65535. If the holdtime is zero, then the holdtime will never expire. It is recommended that the holdtime value is three times that of the keepalive timer. Tick the Default check box to clear the specification of the neighbor specific hold time setting. AS Origination Interval Enter the minimum interval between the sending AS origination routing updates. The (1-600) valid value is from 1 to 600. The default setting is 15 seconds. Connect Retry Interval Enter the minimum interval BGP sends TCP connect requests to the peer after a (1-65535) TCP connection fail happens. The valid value is from 1 to 65535. Tick the Default check box to use the connect retry interval default value. Click the Apply button to accept the changes made. BGP Neighbor Map Settings This window is used to configure BGP neighbor map settings. To view the following window, click L3 Features > BGP > BGP Neighbor > BGP Neighbor Map Settings, as shown below: Figure 5-11932 BGP Neighbor Map Settings window The fields that can be configured are described below: Parameter Description IP Address Click the radio button and use the drop-down menu to select the IP address of the BGP speaking neighbor. Peer Group Name Click the radio button and use the drop-down menu to select the name of the BGP peer group. Unsuppress Map Action Use the drop-down menu to select Add or Delete. Unsuppress Map Name Enter the name of a route map used to selectively advertise routes previously suppressed by the aggregate address command. Route Map Type Use the drop-down menu to select In or Out. In specifies the incoming routes from the neighbor and Out specifies the outgoing routes sent to the peer. Route Map Action Use the drop-down menu to select Add or Delete. Route Map Name Enter the route map to be applied to the incoming or outgoing routes. Click the Apply button to accept the changes made. 242