D-Link DGS-3630-52PC User Manual 1 - Page 165

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide The fields that can be configured are described below: Parameter IPv4 Network Prefix / Prefix Length IPv6 Network Prefix / Prefix Length VID Priority Description Select and enter the IPv4 address and prefix length value for the subnet VLAN here. Select and enter the IPv6 address and prefix length value for the subnet VLAN here. Enter the VLAN ID for the subnet VLAN here. Select the priority value used here. This value is between 0 and 7. A higher value takes higher priority. Click the Apply button to accept the changes made. Click the Delete button to remove the specific entry. Enter a page number and click the Go button to navigate to a specific page when multiple pages exist. Super VLAN This window is used to display and configure the super VLAN settings. This is used to specify a VLAN as a super VLAN. Super VLANs are used to aggregate multiple sub-VLANs (Layer 2 broadcast domains) into an IP subnet. A super VLAN cannot have any physical member port. A super VLAN cannot be a sub-VLAN at the same time. Once an IP interface is bound to a super VLAN, the proxy ARP will be enabled automatically on the interface for communication between its sub-VLANs. Multiple super VLANs can be configured and each super VLAN can consist of multiple sub-VLANs. Private VLAN and super VLAN are mutually exclusive. A private VLAN cannot be configured as a super VLAN. Layer 3 routing protocols, multicast protocols, and the IPv6 protocol cannot run on a super VLAN interface. To view the following window, click L2 Features > VLAN > Super VLAN, as shown below: Figure 5-31 Super VLAN Window The fields that can be configured in Add Super VLAN are described below: Parameter Super VID List Description Enter the super VLAN ID(s) that will be created here. Click the Apply button to accept the changes made. 153