D-Link DIS-300G-14PSW CLI Manual - Page 25
Enable Mode Commands
![]() |
View all D-Link DIS-300G-14PSW manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
3.2 Enable Mode Commands All the "show - -" commands in this section can also be executed under any other command mode except Initialize Mode. 3.2.1 configure terminal Description Enter configuration mode. Syntax configure Parameter None 3.2.2 disable Description Syntax Parameter Enter init mode. disable None 3.2.3 show aaa Description Syntax Parameter Show AAA show aaa None 3.2.4 show access management Description Access management configuration Syntax show access management [ statistics | ] Parameter Name Description statistics Statistics data access_id_list ID of access management entry 3.2.5 show access-list Description Access list Syntax show access-list [ interface [ ( [ ] ) ] ] [ rate-limiter [ ] ] [ ace statistics [ ] ] Parameter show access-list ace-status [ static ] [ link-oam ] [ loop-protect ] [ dhcp ] [ ptp ] [ upnp ] [ arp-inspection ] [ mep ] [ ipmc ] [ ip-source-guard ] [ ipmgmt ] [ conflicts ] [ switch ] Name interface ace-status port_type v_port_type_list rate-limiter rate_limiter_list ace statistics ace_list static loop-protect ipmc ip-source-guard dhcp conflicts Description Select an interface to configure The local ACEs status GigabitEthernet,1 Gigabit Ethernet Port PORT_LIST, Port list in 1/1-14 Rate limiter Rate limiter ID Access list entry Traffic statistics ACE ID The ACEs that are configured by users manually The ACEs that are configured by Loop Protect module The ACEs that are configured by IPMC module The ACEs that are configured by IP Source Guard module The ACEs that are configured by DHCP module The ACEs that did not get applied to the hardware due 13
![](/manual_guide/products/dlink-dis300g12sw-cli-manual-a95bea6/25.png)