D-Link DIS-300G-14PSW Quick Installation Guide - Page 7

Quick Installation Guide CLI Initialization & Configuration 1. Connecting to the Ethernet port(RJ45 Ethernet port) of Managed Switch 2. Key-in the command under Telnet: telnet 10.90.90.90 3. Login with default account and password. Username: admin Password: admin 4. Change the IP with commands listed below: CLI Command: enable configure terminal interface vlan 1 ip address xxx.xxx.xxx.xxx xxx.xxx.xxx.xxx exit LED STATUS INDICATIONS LED Name Indicator /color Condition P1/P2 On Green Off P1/P2 power line has power P1/P2 power line disconnect or does not have power supplied Alarm On Red Off Ethernet link fails, alarm or power failure alarm occurs No Ethernet link fails and no power failure alarm Copper port Link/Act On Green Flashing Green Off Ethernet link up but no traffic is detected Ethernet link up and there is traffic detected Ethernet link down Copper port Speed On Yellow Off A 1000Mbps connection is detected No link, a 10Mbps or 100 Mbps connection is detected SFP port Link/Act On Green Off Ethernet link up Ethernet link down SFP port Speed On Yellow Off SFP port speed 1000Mbps connection is detected. No link or a SFP port speed 100Mbps connection is detected DIS-300G-8PSW/DIS-300G-14PSW only RR (Ring Role) On Green Off One of 3 Ring group is enabled and is Master role. Ring is slave role RS On Green (Ring Status) Off Ring fail happen and detected No ring fail detected On Yellow PoE is detected PoE Off No link 7