D-Link DSN-5210-10 Hardware Reference Guide for DSN-5000-10 - Page 45
Replacing the I/O Module on the Expansion Array
UPC - 790069323980
View all D-Link DSN-5210-10 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 45 highlights
A.4 Replacing the I/O Module on the Expansion Array Use the following procedure to replace the I/O module on the expansion array. 1. Power down the DSN-5000 series primary and DSN-5000-10 expansion array and remove the power cords from the back panel. 2. Squeeze down on the top of the levers on either side of the I/O module on the DSN- 5000-10 expansion array and pull down to disengage the module, then pull the module straight out of the enclosure. 3. Install a replacement I/O module in the expansion array by keeping the levers on the left and right sides down, then slide the module into the enclosure until you feel it engage into place. 4. Replace the power cords and power on the DSN-5000 series primary array and DSN-500010 expansion array. Figure A-5. Removing the I/O Module on the Expansion Array (Slot #0 shown) DSN-5000 series Hardware Reference Guide 37