D-Link DXS-3600-EM-4QXS CLI Guide - Page 151
Origin codes, IP Address/Netmask, Gateway, Metric, LocPrf, Weight, IP Prefix List, entries, permit
View all D-Link DXS-3600-EM-4QXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 151 highlights
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Display Parameters Origin codes IP Address/Netmask Gateway Metric LocPrf Weight Path Description Origin of the table entry displayed at the end of each line. It can be one of the following values: i - Entry originated from an Interior Gateway Protocol (IGP) and was advertised with a network router configuration command. e - Entry originated from an Exterior Gateway Protocol (EGP). ? - Origin of the path is not clear. Usually, this is a router that is redistributed into BGP from an IGP. IP prefix with its mask length of the entry. IP address of the next router that is used when forwarding a packet to the destination network. An entry of 0.0.0.0 indicates that the router has some non-BGP routes to this network. If shown, this is the value of the inter-autonomous system metric. This field is frequently not used. Local preference value as set with the set local-preference route-map configuration command. The default value is 100. Weight of the route as set via autonomous system filters. Autonomous system paths to the destination network. Example This example shows how to display the IP prefix-filter received from the neighbor 10.1.1.1 by ORF. DXS-3600-32S#show ip bgp neighbors 10.1.1.1 received prefix-filter ip prefix-list 10.1.1.1.1.1: 2 entries seq 5 permit 8.8.8.0/24 le 32 seq 10 permit 9.9.9.0/24 le 32 DXS-3600-32S# Display Parameters IP Prefix List entries Seq permit deny le ge Description Name of the IP prefix list received from the neighbor. The name is made up by the IP address by the dotted decimal notation dot Address Family Identifier (AFI) dot Subsequent Address Family Identifier (SAFI). Number of entries of the prefix list. Sequence number of the entry. Indicates that routes matched the IP prefix behind will be advertised to the neighbor. Indicates that routes matched the IP prefix behind will not be advertised to the neighbor. Less than or equal. Indicates the length of the mask. Greater than or equal. Indicates the length of the mask. Example This example shows how to display all the unprocessed routes received only from the 10.1.1.2 neighbor. These routes are contained in the Adj-RIB-In associated with the neighbor 10.1.1.2. DXS-3600-32S#show ip bgp neighbors 10.1.1.2 received-routes BGP Local Router ID is 10.90.90.90 Status codes: s suppressed, d damped, h history, * valid, > best, i - internal Origin codes: i - IGP, e - EGP, ? - incomplete IP Address/Netmask Gateway Metric LocPrf Weight Path *>172.18.0.0/24 *>172.18.1.0/24 *>172.18.2.0/24 10.1.1.2 0 10.1.1.2 0 10.1.1.2 0 0 10 i 0 10 i 0 10 i DXS-3600-32S# 143