D-Link DXS-3600-EM-4QXS CLI Guide - Page 242
show ets interface
View all D-Link DXS-3600-EM-4QXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 242 highlights
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide cos-map COS-QUEUE COS-VALUE [, | -] Specifies the recommended Priority Assignment Table. COS-QUEUE: Specifies the queue ID (Traffic Class) for the specified priority. The value is from 0 to N. The N is the number of traffic classes supported per port. COS-VALUE: Specifies the priority to be mapped. The value is from 0 to 7.You can specify multiple priorities queued into the specified traffic class. Default Command Mode Command Default Level Usage Guideline The recommended bandwidth is 4, 7, 11, 14, 18, 21, 25 (in percentage) for Traffic Classes 0 to 6 respectively. 0 for Traffic Class 7 means the recommended transmission selection algorithm is "strict priority". The default priority (CoS) to Traffic Class mapping is: • 0 -> 1 • 1 -> 0 • 2 -> 2 • 3 -> 3 • 4 -> 4 • 5 -> 5 • 6 -> 6 • 7 -> 7 Interface Configuration Mode. Level: 15. This command is available for physical port configuration. Use this command to specify the recommended bandwidth (in percent) for each Traffic Class. The value of zero means using "strict priority" for the corresponding Traffic Class. You need to enable the Switch to transmit LLDP DCBX ETS-Recommendation TLVs to advertise the ETS recommendation. If the command no ets recommand is issued without any keywords, all ETS recommendation settings (bandwidth and priority assignments) will be reverted to their default values. Example This example shows how to configure the recommended transmission selection algorithm for Traffic Class 0 to 4 as ETS (Enhanced Transmission Selection) and the allocated bandwidth is 10%, 10%, 20%, 20%, 40% respectively. For Traffic Classes 5 to 7 the recommended transmission selection algorithm is strict priority. DXS-3600-32S#configure terminal DXS-3600-16S(config)#interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config-if)# ets recommend bandwidth 10 10 20 20 40 0 0 0 DXS-3600-32S(config-if)# Example This example shows how to configure the recommended Priority Assignment Table, to assign priority 1-2 to Traffic Class 2 at interface 1/0/1. DXS-3600-32S#configure terminal DXS-3600-16S(config)#interface tenGigabitEthernet 1/0/1 DXS-3600-32S(config-if)# ets recommend cos-map 2 1-2 DXS-3600-32S(config-if)# 19-3 show ets interface This command is used to display the ETS information of a given interface or all interfaces. show ets interface [INTERFACE-ID [, | -]] [recommend] Parameters INTERFACE-ID , (Optional) Specifies that valid interfaces are physical interface. (Optional) Specifies a series of interfaces, or separate a range of interfaces from a previous range. No space before and after the comma. 234