D-Link DXS-3600-EM-4QXS CLI Guide - Page 450
ip route
View all D-Link DXS-3600-EM-4QXS manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 450 highlights
DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide Default Command Mode Command Default Level Usage Guideline By default, dip and crc32_lower is set. Global Configuration Mode. Level: 8 User can use any combination of dip, port, sip, crc32_lower or crc32_upper to build the Hash algorithm. sip, crc32_lower or crc32_upper are mutually exclusive with each other. User is required to select one and only one of them. The no form of this command will remove the keywords it carries with as the components of a key from the saved setting. For example, if the system saves the setting of sip, dip and port. After the no ip ecmp load-balance dip port is executed, only sip is available for the key. If the no form of this command has the keywords not in the saved settings, the command runs properly. If using the no form of this command without any keywords, the configuration will go back to the default settings. Use show ip ecmp load-balance to check the current setting of load-balancing algorithm. Example This example shows how to set the load-balancing algorithm to use sip and TCP or UDP port. DXS-3600-32S#configure terminal DXS-3600-32S(config)#ip ecmp load-balance sip port DXS-3600-32S(config)# 46-6 ip route This command is used to add a static route entry. Use no form of this command to remove a static route entry. Primary and backup are mutually exclusive. Users can select only one when creating a new route. If user sets neither of these, the system will try to set the new route first by primary and second by backup and not set this route to be a multipath route. The weight is used to configure the equal cost multiple paths (WCMP) function. ip route [vrf vrf-name] network net-mask {ip-address [{primary | backup | weight number}] | null0 | ip_tunnel tunnel-name} no ip route [vrf vrf-name] network net-mask {ip-addres | null0 | ip_tunnel tunnel-name} Parameters vrf vrf-name network net-mask ip-address primary backup weight number null0 ip_tunnel tunnel-name (Optional) Specifies to add this static route to the VRF routing table. Specifies the network address of the destination. The destination of the route is determined by network and net-mask. Specifies the network mask of the destination. Specifies the IP address of the next-hop router (Optional) Specifies the route as the primary route to the destination. (Optional) Specifies the route as the backup route to the destination. (Optional) Specifies a weight number greater than zero, but not greater than the maximum paths number for the WCMP. This number is used to replicate identical route path (multiple copies) in routing table, so the path get more chance to be hit for traffic routing. Specifies a black hole route. Specifies to use an IP tunnel as the next-hop. Default Command Mode By default, no static route is configured. Global Configuration Mode. 442