D-Link DXS-3600-EM-4QXS Hardware Installation Guide - Page 10

DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide • • • Management Information Base (MIBs) for MIBII, Bridge MIB, SNMPv2 MIB, RMON MIB, RMONv2 MIB, Ether-like MIB, 802.3 MAU MIB, 802.1p MIB, IF MIB, RADIUS Authentication Client MIB, IGMPv3 MIB, RIPv2 MIB, IP Forward- ing Table MIB (CIDR), IPv4 Multicast Routing MIB, PIM MIB for IPv4, RADIUS Accounting Client MIB, Ping MIB, Trace out MIB, L2 Specific MIB, L3 Specific MIB, OSPFv2 MIB, VRRP MIB, Private MIB, Entity MIB. Front Panel Components The front panel of the switch consists of LED indicators, an SD card slot, an Out-Of-Band Management port (MGMT), a Console port, SFP+ ports and an open module slot. Figure 1-1 Front panel view of the DXS-3600-32S LED Indicators Located on the front panel of the switch are LED indicators: Power1, Power2, MGMT, Console, Fan1, Fan2, Fan3, SD, and the Seven segment stacking ID LED. For each SFP+ port there is a Link/Act light. LED Power1, Power2 Management (MGMT) Console Figure 1-2 LED indicators for the DXS-3600-32S Description This LED will light solid green after the Switch has been powered on successfully. This LED will light solid orange if the Switch's power supply fails. This LED will be off when the Switch is no longer receiving power (i.e. powered off). This LED will light solid green after a link to the management port was successfully established. This LED will blink when activity on this port is taking place. This LED will be off when there is no link present or when this interface was shutdown from within the switch's configuration. This LED will blink green during the Power-On Self Test (POST). This LED will light solid green when a user is logged in through the console port. This LED will be off after the POST finished successfully and no user is connected to the console port. 3