D-Link DXS-3600-EM-4QXS Hardware Installation Guide - Page 20

Installing Fan Modules into the Fan Module Ports

Get D-Link DXS-3600-EM-4QXS PDF manuals and user guides View all D-Link DXS-3600-EM-4QXS manuals
Add to My Manuals
Save this manual to your list of manuals

Page 20 highlights

DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide • Use a minimum of 18 AWG stranded copper wire for grounding. The wire should be long enough to reach from the installed switch to the facility ground point. • Torque screwdriver with a 1/4-inch flat blade. • Ground additional hardware appropriately to the earth ground connection at your site. Installing Fan Modules into the Fan Module Ports Located on the rear panel of this switch there are three fan module ports. Figure 2-9 Installing a Fan Module The user can easily remove and insert fan modules into these ports. NOTE: All fan modules, installed in this switch, should support the same air-flow direction to prevent thermal issues. 13

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
DXS-3600-32S 10GbE Layer 2/3 Switch Hardware Installation Guide
13
• Use a minimum of 18 AWG stranded copper wire for grounding. The wire should be long enough to reach from the
installed switch to the facility ground point.
• Torque screwdriver with a 1/4-inch flat blade.
• Ground additional hardware appropriately to the earth ground connection at your site.
Installing Fan Modules into the Fan Module Ports
Located on the rear panel of this switch there are three fan module ports.
Figure 2-9 Installing a Fan Module
The user can easily remove and insert fan modules into these ports.
NOTE:
All fan modules, installed in this switch, should support the same air-flow direction to prevent
thermal issues.