DELPHI SA10035 User Guide - Page 18
the heater on. Remove the liner from the adhesive pad and adhere to
UPC - 689604153925
View all DELPHI SA10035 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
Section 5 18 3. Clean the vehicle mounting surface with the enclosed surface preparation cleaning kit. Wipe with the towelette in only one direction. Do not wipe the surface in a circular motion or back and forth. Dry area with a clean, dry cloth. Wipe dry in the same direction again and then repeat this cleaning process. Allow to air dry thoroughly to ensure effective adhesion. 4. Clean the same surface with the enclosed alcohol prep pad. Wipe in the same direction and manner as with the towelette. Dry the area with a clean, dry cloth, wiping in one direction. Allow to air dry thoroughly. Ensure that the surface is at least 60°F. 5. Warm the car mount adhesive pad by using a hair dryer or by placing the car mount on top of the vehicle's defrost outlet for several minutes with the heater on. Remove the liner from the adhesive pad and adhere to the vehicle's surface. Make sure you accurately place the pad on the first try since in many cases it will bond almost immediately. 3M recommends a 72-hour curing time for maximum adhesion. 6. Clip the Roady Receiver onto the car mount (figure 5). To vehicle dashboard Figure 5. Attach car mount to back of Roady Receiver as shown.