DELPHI SA10101 Installation Guide - Page 19
FCC Statement, Important - xm skyfi2 satellite radio receiver
UPC - 956235124205
View all DELPHI SA10101 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
SKYFi2 install guide layout 6/20/06 4:47 PM Page 20 FCC Statement This equipment has been tested and found to - Reorient or relocate the receiving antenna. 1 9 Please note that the cables and antenna wire comply with the limits for a Class B digital - Increase the separation between the that have been supplied with your device are device, pursuant to Part 15 of the FCC Rules. equipment and the receiver. supplied with permanently attached ferrite These limits are designed to providereason- - Connect the equipment into an outlet on a beads. It is the responsibility of the user to able protection against harmful interference circuit different from that to which the use the cable and antenna wire with the in a residential installation. receiver is connected. ferrite beads. - Consult the dealer or an experienced This equipment generates, uses, and can radio/TV technician for help. The user is cautioned that changes or modifi- radiate radio frequency energy and, if not cations not expressly approved by XM installed and used in accordance with the Important: The FCC and FAA have not cert i- Satellite Radio, Inc. can void the user's authority to operate this device. This device complies with Part 15 of the FCC rules. Operation is subject to the following instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interf e rence to radio or fied the Delphi XM SKYFi2 Satellite Radio Receiver for use in any aircraft (neither portable nor permanent installation). T h e re f o re,Delphi cannot support this type of application or installation. two conditions: (1) This device may not cause television reception, which can be deter- harmful interference, and (2) this device must mined by turning the equipment off and on, accept any interference received, including the user is encouraged to try to correct the interference that may cause undesired interference by one or more of the following o p e r a t i o n . m e a s u re s :