Dacor DMO24 Installation Instruction - Over the Range Microwave Oven/Hood Syst - Page 5

(B) HORIZONTAL EXHAUST: Outside Ventilation 1. Remove and save 2 screws from back edge and 1 screw from the top center of Fan Cover Bracket. Remove Fan Cover Bracket by sliding it in the opposite direction of the arrow on the Fan Cover Bracket, as shown in Figure 7. 2. Withdraw Hood Fan Unit carefully and slip wires out of Wire Box. See Figure 8. CAUTION: Do not pull or stretch hood fan wiring. 3. Rotate the Hood Fan Unit and turn end-over-end so that the fan blade openings are facing the back of the oven. Replace Hood Fan Unit into the oven. Be careful not to pinch the lead wire between the inner bracket and the Hood Fan Unit. See Figure 9. 4. Put the lead wire into Wire Box. See Figure 10. 5. Replace the Fan Cover Bracket by sliding it into the slits in the same direction as the arrow on the Fan Cover Bracket. Make sure the fan blades are visible through the rear openings in the oven before proceeding. Attach Fan Cover Bracket to unit with 3 screws, which were removed in Step 1 above. See Figure 10. The Hood Fan Unit is now rotated for horizontal exhaust operation. 6. Attach the Exhaust Damper Assembly 8 to the back of the Mounting Plate by sliding it into the slits in the same direction as the arrow. See Figure 11. Use Tapping Screw 4 X 12 7 from the INSTALLATION HARDWARE and tighten into place. Fan Cover Bracket Back of Oven Figure 7 Figure 8 Figure 9 Figure 10 Wire Box Exhaust Damper Assembly 8 Mounting Plate (Back Side) Figure 11 Tapping Screw 7 5