Dacor DTHP48 Installation Instruciton - Distinctive Wall Mount Range Hood - Page 14
Installation Instructions
View all Dacor DTHP48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
Installation Instructions Marking the Centerlines These measurements and marks are for centering and leveling the hood, marking the duct cutouts, and installing the holding brackets. The holding brackets temporarily hold the hood while you mount it permanently into place. Have a marking tool, tape measure, and level ready. 1. Position the hood in the same orientation as it will be when installed. (For example, if it is a top vent installation, set the hood with the vents on top.) 2. Measure the distance from the edge of the hood to the center of the exhaust port. 3. Transfer that measurement to the wall (for a rear vent), or overhead (for top vent). Measure the X and Y axis to find the centerline. 4. Extend the line down 10 inches (25.4 cm). 5. Cut a hole that is 1 inch larger than the duct. Dual exhaust models require two (2) holes. Top Exhaust CL 48" (121.92 cm) Top Exhaust Centerline CL 9 7/8" (25.08 cm) DTHP48 Top and Rear Exhaust Centerline 14 1/8" (35.88 cm) Rear Exhaust CL Rear Exhaust Centerline 12