Dacor DTHP48 Installation Instruciton - Distinctive Wall Mount Range Hood - Page 20
Using the Dual to Single, Transition Kit# AHT10
View all Dacor DTHP48 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Installation Instructions Using the Dual to Single Transition Kit# AHT10 On dual exhaust models, the two 8-inch duct exhausts can be transitioned into one 10-inch duct. Assemble the Dacor transition kit # AHT10 before hanging the hood. This transition kit fits over the top or rear ventilation exits. Bending the Flange for: • Top Vent Configuration On models 3010, 3610, 4810 2" (5.1 cm) 32" (81.3 cm) 13 3/4" (34.9 cm) 9" (22.9 cm) 3/4" (1.9 cm) IMPORTANT: DTHP3010, 3610, 4810 models CANNOT vent through the rear ducts. DTHP3010, 3610, 4810 X Four (4) corners are bent backward 90 degrees. Installing the AHT10 Top Vent: 3010, 3610, 4810 1. Center the AHT10 transition kit over the duct collars. 2. Drill holes for screws in the flanges. Make sure the holes pierce the top of the hood (see right). 3. Fasten the AHT10 into place using sheet metal screws (not included). 4. Seal the base of the AHT10 with foil or duct tape. Top Vent: 3010, 3610, 4810 Preparing the AHT10 1. Create a lip around the transition kit by bending the bottom edges backward at right angles to create a 3/4" flange around the base. Dual vent model is shown 18