Dacor DTHP48 Installation Instruciton - Distinctive Wall Mount Range Hood - Page 21

Installation Instructions Hanging the Range Hood WARNING Hanging the range hood requires two people. Do not attempt to lift the hood without assistance. When hanging the hood, be careful not to scratch or damage the hood. 1. Remove the plastic film from the hood. There are hanging slots in the back of the hood a few inches from the top. The holding brackets on the wall engage here and temporarily hold the hood in place. 2. Lift the hood up and catch holding brackets in the hanging slots in the back of the hood (see figure Hanging the Hood). 3. Adjust the hood into its final position. 4. Mark the spot by drawing in a mounting hole in the back of the hood (see figure Hanging and Mounting Slots ). This is where a screw will hold the hood to the wall stud or (concrete) anchor. 5. Mark the top of the hood if the configuration calls for the hood to be secured at the top. 6. Remove the hood from the wall. 7. Drill the pilot or anchor holes. If using anchors, insert them into the anchor holes. 8. Reattach the hood to the holding brackets. 9. Adjust the hood into its final position and fasten it into place: Insert the fasteners through the mounting slots in the back and top of the hood and into the studs, mounting blocks, or anchors. Holding brackets Hanging the Hood Hanging slots in the back of the hood Mounting slots Hanging and Mounting Slots 19