Dacor HWO230 User Manual - Wall Oven - Page 16

CARE AND CLEANING Cleaning the Meat Probe CAUTION • Do not immerse the meat probe in water. • To ensure proper function, dry the probe's plug completely before connecting it to the oven. The meat probe has silicone handles, a wire, a plug and a stainless-steel skewer. To clean the skewer, use a scouring pad and hot, soapy water. When you clean the handles, wipe them with a soft sponge soaked with a solution of detergent and warm water. Dry thoroughly. To clean the filter: Soak it in hot, soapy water, then rinse it well, or put it in the dishwasher's top rack. Wipe the filter dry, thenre-install it. To install the convection filter: Replacing the Light Bulbs This task can be done by the homeowner. If none of the lights work, before replacing them, consult the Problem Solution Guide, pg. 17. WARNING Clips Taking care not to mar the porcelain with the filter, center the it over the fan hole, and carefully hook the metal clips over the bar across the hole. • To prevent an electric shock hazard and personal injury, turn off power to the oven, and ensure the oven and bulbs are cool. • Only use the oven with the lens covers installed. The covers protect the bulbs from high temp's and mechanical shock. • Replacing the lens cover without lining up the cutout with the light socket will damage the light fixture. • Do not use a screwdriver to remove the lens. IMPORTANT Do not touch the replacement halogen bulbs with your fingers. Oils from your hand make the bulbs burn out faster than normal. Cleaning the Door Gasket WARNING Clean the door gasket with extreme caution to avoid compromising the seal required for proper cooking and self-cleaning. Clean the door gasket by dabbing it with a solution of water and mild soap. Do not scrub it or it will become damaged. Cleaning the Oven Racks CAUTION Do not self-clean the oven racks. To clean the oven racks, apply a hot water-detergent solution. For heavy soil, use a scouring pad with ample water. (Instead of water, you may use a solution of 1 cup of ammonia to 2 gallons of water.) 1. Replace the light bulb only with Dacor bulb PN 100429, 12V 20W. (Visit www.everythingdacor.com for ordering information.) 2. Turn off power to the oven at the circuit breaker/fuse box. 3. Supporting the lens from below, gently pry it loose with a table knife, and pull the lens cover straight out. Light socket Light bulb 4. Pull the old bulb straight out of the socket. 5. Wearing a glove, take the new bulb, and insert it in the socket. 6. In reinstalling the Cutout on inside rim of lens lens cover, line up the cutout on the inside rim with the light socket, and gently press it into place. 7. Return power to the oven, and reset the clock (pg. 4). 14