Dacor RV30 Installation Instructions - Page 16
Final Installation, Verifying Proper Operation, Installation Checklist - service manual
View all Dacor RV30 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 16 highlights
Installation Instructions Final Installation Install the cooktop according to its installation instructions. Set the cooktop into the countertop opening so that the back edge of the cooktop overlaps the leading edge of the vent. Verifying Proper Operation warning • Read the raised vent use and care manual completely before operation. • Make sure the filters are installed prior to operating the raised vent. Refer to the use and care manual for filter installation instructions. 1. Turn on power to the raised vent at the circuit breaker panel or fuse box. 2. Press the UP/DOWN button once to raise the vent to its operating position. Once in the up position, the blower should come on and the vent should begin to draw in air. 3. Push the OFF, LOW, MEDIUM and UP/DOWN HIGH buttons in turn to make sure the speed changes or the blower turns off. Installation Checklist warning In the interest of safety, perform the following checklist to make sure the unit has been properly installed. Proper installation is the responsibility of the consumer. □□ Are the anchor legs extended down to make contact with the floor and tightened into place? Are the anchor legs fastened to the floor? Is the unit level? □□ Is the duct work completely installed? Are all joints attached with sheet metal screws and wrapped with duct tape? □□ Is the Input Power for the raised vent connected to the junction box? Are all terminals tight? □□ Is the blower power input connected to the Output Power terminals on the raised vent? Are all terminals tight? □□ Is the wiring routed away from the hot surfaces of the cooktop. □□ Are the vent filters installed according to the use and care manual? □□ Has proper operation been verified? □□ Has the warranty been activated on-line or the warranty card been filled out completely and mailed? OFF LOW MED HIGH 4. Press the UP/DOWN button once to lower the vent. 5. Make sure that the top cap on the raised vent intake does not catch on the back edge of the cooktop when the intake is lowered. If interference occurs, adjust the position of the cooktop to prevent damage. If the raised vent is not operational after installation: • Make sure that power is being supplied to the raised vent and to the blower (via the raised vent). • If the vent will not raise properly or makes a scraping sound, remove the vent cover or cabinet blower and check for obstructions interfering with the raising mechanism. Replace the vent cover or cabinet blower and make sure it is properly centered over the opening on the front of the raised vent. If the raised vent still does not function after performing the above checks, do not attempt to repair it yourself. Contact Dacor Distinctive Service at (877) 337-3226. Have the model and serial numbers from the product data labels for the raised vent and the blower available when you call. Dacor is not responsible for the cost of correcting problems caused by a faulty installation. 14