Danby DAC15009EE Product Manual - Page 6
Features
View all Danby DAC15009EE manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
FEATURES UNIT CONTROL PANEL 56 2 1) On/Off Button: Press to turn unit on/off. 2) Temp. Up/Down Buttons: To change temp. setting, press or hold either Up ( ) or Down ( ) button until the desired temperature is seen on the display. This temp. will be automatically maintained (anywhere between 17°C and 30°C (62°F and 86°F). If you want the display to read the room temp., see "To Operate on Fan Only" section. 3) Fan Speed Button: Used to select the Fan Speed; Auto, High, Med. or Low. Each time the button is pressed, the fan speed mode is shifted. 4) Mode Button: Press to choose operating mode; each time you press, a mode is selected, from; Auto, Cool, Fan, and Dry. The appropriate indicator light beside mode button will illuminate and remain on 4 7 once mode is selected. 8 1 3 To operate Auto Mode: • In this mode, the fan speed cannot be adjusted; it starts automatically at a speed according to the room temperature. If the room does not get too warm, the fan will remain at Low speed. To operate Fan Only Mode: • Use this function when cooling is not desired, such as for room circulation or to exhaust stale air. Remember to open the vent during this function, but keep it closed during cooling for maximum cooling efficiency. In this mode you can choose any fan speed you prefer. 5) Energy Saver Button: In this mode, the fan will continue to run for 3 minutes after the compressor shuts off. The fan then cycles on for 2 minutes at 10 minute intervals until the room temperature is above the set temperature, at which time the compressor turns back on and cooling starts. 6) Sleep Button: In this mode the selected temp. will increase by 2 degrees 30 minutes after the mode is selected. The temp. will then increase by another 2 degrees after an additional 30 minutes. This new temp. will be maintained for 7 hours before it returns to the originally selected temp. This ends the Sleep mode and the unit will continue to operate as originally programmed. The sleep mode program can be cancelled at any time during operation by again pressing the Sleep button. 7) Timer (Auto Start / Stop Feature) Button: Pressing Timer button will illuminate indicator beside the word "On"; this indicates the Auto Start program is initiated. Press or hold the Up ( ) or Down ( ) buttons to change the Auto time by 0.5 hour increments, up to 10 hours, then at 1 hour increments up to 24 hours. The control will count down the time remaining until start. The selected time will register in 5 seconds and the system will automatically revert back to display the previous temp. setting. Turning the unit ON or OFF at any time will cancel the Auto Start/Stop function. 8) Check Filter Button: This feature is a reminder to clean the Air Filter for more efficient operation. The LED (light) will illuminate after 250 hours of operation. To reset after cleaning the filter, press the Check Filter button and the light will go off. ADDITIONAL FEATURES: • The Cool circuit has an automatic 3 minute time delayed start if the unit is turned off and on quickly. This prevents overheating of the compressor and possible circuit breaker tripping. The fan will continue to run during this time. • The control will maintain any set temp. within 2°, between 15°C - 32°C (60°F - 90°F) • The control is capable of displaying temp. in Celsius (°C) or Fahrenheit (°F). To convert from one to the other, press and hold the Up and Down Temp./Timer buttons at the same time for 3 seconds. 5