Danby DCR34 Product Manual - Page 2
nAVOINV, DANGER, child, entrapment., Before, throw, refrigerator, freezer, doors, Leave, shelves,
View all Danby DCR34 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
PIEZAS de REPUESTO Modelos DCR34W Y DCR34BL 50 PIEZAS NO ILUSTRADAS 0 45 43 O 39 8 8 00 ° 0 0 o 0 0 0 30 4 25 w inAVOINV O 0/ ------------ 0 0 000 G. 13 g Ito K to 23 0 21 ATTENTION GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electrical shock by providing an escape wire for the electrical current. This appliance is equipped with a cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. WARNING - Improper use of the grounding plug can result in a risk of electric shock. Consult a qualified electrician or serviceman if the grounding instructions are not completely understood, or if the doubt exists as to whether the appliance is properly grounded. DO NOT USE AN EXTENSION CORD Use an exclusive wall outlet. Do not connect your refrigerator to extension cords or together with any other appliance in the same wall outlet. Do not splice the cord. IMPORTANT WARNING An empty refrigerator is a very dangerous attraction to children. Remove either the gasket, latches, lids or doors from unused appliances, or take some other action that will guarantee it harmless. DANGER: Risk of child entrapment. Before you throw away your old refrigerator or freezer: • Take off the doors • Leave the shelves in place so that children may not easily climb inside. DON'T WAIT DO IT NOW! Installation Remove the exterior and interior packings, wipe the outside thoroughly with a soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the cabinet in a narrow recess or near any heat source, direct sunlight, or moisture. Let air circulate freely around the cabinet. Keep the rear of the refrigerator 5 inches away from the wall. Location 1. Select a place with a strong, level floor. 2. Allow 5 inches of space between the back of the refrigerator and any adjacent wall. 3. Avoid direct sunlight and heat. Direct sunlight may affect the acrylic coating. Heat sources nearby will cause higher electricity consumption. 4. Avoid very moist places. Too much moisture in the air will cause frost to form very quickly on the evaporator, and your refrigerator will have to be defrosted very frequently. Operation To avoid vibration, the cabinet must be set level. To start the refrigerator, turn the temperature control to the position corresponding to the desired cooling. The refrigerator temperature will vary depending on the quantity of the food stored and on the frequency with which the door is opened. Turn the control to the "0 " position to temporarily disconnect the cooling cycle. After defrosting and if the refrigerator has been left out of use for some time, set the control to maximum for 2 to 3 hours before turning to the desired position. When the refrigerator is not to be used for a long period of time, disconnect the plug and leave the door partially open. Note: Wait 3 to 5 minutes before restarting if operation has been interrupted Ice Cube Tray Ice cube tray is flexible. Twist tray to remove ice cubes. if the ice cube tray is frozen hard to the evaporator surface, run a little water over the tray. Never use a knife or other metal instrument to remove ice cube tray because this may damage the evaporator. (Fig. C) Fig. C 2