Danby DPAC13009 Product Manual - Page 5

IMPORTANT SAFETY INFORMATION POWER SUPPLY CORD The power cord supplied with this air conditioner contains a device that senses damage to the power cord. To test if your power cord is working properly, you must do the following: 1) Connect the power supply cord to an electrical outlet. NOTE: The power cord supplied with this air conditioner contains a current leakage detection device designed to reduce the risk of fire. In the 2) The power supply cord has two buttons event the power supply cord is damaged, it cannot located on the head of the plug. One button is be repaired and must be replaced with a new cord marked "TEST", and the other is marked from the product manufacturer. "RESET". Press the "TEST" button; you will hear a click as the "RESET" button pops out. • Under no circumstances should this device be used to turn the unit on or off. 3) Press the "RESET" button; you will hear a click as the button engages. • The "RESET" button must always be pushed in (engaged) for correct operation. 4) The power supply cord is now energized and supplying electricity to the air conditioner • The power supply cord must be replaced if it fails (on some products this is also indicated by a to reset when the "TEST" button is pushed in. light on the plug head). ENERGY-SAVING Your Danby appliance is designed to be highly efficient in energy TIPS savings. Follow these recommendations for greater efficiency. 1) Select a thermostat setting that suits your 4) Start your air conditioner before the comfort needs and leave at that chosen setting. outdoor air becomes hot and uncomfortable, to avoid an initial period of discomfort while the unit is cooling off the room. Use of the 2) The air filter is very efficient in removing airborne particles. Keep the air filter clean at all times. automatic start/stop programmable TIMER feature can be a major asset in this regard if utilized to the fullest extent. 3) Use drapes, curtains or shades to keep direct sunlight from penetrating and heating room, but do not allow drapes or curtains to obstruct the air flow around the unit. 5) When outdoor temperatures are cool enough, turn the air conditioner off and use the FAN MODE on HIGH, MED, or LOW. This circulates indoor air, providing some cooling comfort while utilizing less electricity. INTERNAL SAFETY FEATURE This unit is equipped with a fail-safe switch mechanism that prevents the unit from condensing water in the event the internal reservoir becomes full or is accidentally displaced. If this situation occurs, the (RED) WATER FULL indicator light will illuminate. This condition will remain steady until the external water tank is emptied. NOTE: No cooling will occur until the internal tank is emptied and/or re-positioned. It may take several minutes before the compressor resumes normal operation. CAUTION: During air conditioning and dehumidifier mode, if the compressor cycle is interrupted (water full condition, unplugged, power failure, etc.) and reinstated immediately thereafter (within 3-5 minutes), a compressor protection circuit is automatically activated. The compressor cannot operate during compressor protection mode (this is normal). It may take 3-5 minutes before the protection circuit self-deactivates. DO NOT ATTEMPT TO START THE UNIT (COMPRESSOR) DURING THIS PERIOD. 4