DeLonghi ESAM6600 Owner Manual - Page 12

16.3 Cleaning the milk container Proceed as follows: • Remove the milk spout (1) and intake tube (2). • Remove the froth regulator (3) by pulling it outwards (see figure) • Wash all the components thoroughly with hot soapy water. Make sure there is no milk residue inside the two holes in the lid of the milk container,indicated by the arrows in the figure,or in the groove (4) of the froth regulator. • Replace the froth regulator, intake tube and milk spout back in the milk container lid. 4 3 1 2 17 CHANGING AND SETTING THE MENU PARAMETERS After pressing the button, when the appliance is ready, you can use the internal menu to modify the following parameters and functions: • Clock • Auto-start time • Auto start ON/OFF • Descaling process • Coffee temperature • Length of time the appliance remains on • Water hardness • Resetting factory default values • Washing procedure • BEEP ON/OFF Note: the last line of the display is the guide to the function buttons. 17.1 Setting the clock To set the clock, proceed as follows: • Press the P button, then press the button (corresponding to the repeatedly until the menu arrow is on: symbol flashing on the display) CLOCK 00:00 • Press the button (corresponding to the SET symbol flashing on the display) to set the time on the clock. (If you hold the button down, the time is changed rapidly.) • Press the OK button to confirm the value. • Press the P button (corresponding to the ESC symbol flashing on the display) to exit programming mode or to change other parameters. Note: to display the time with the appliance off, press any button. The time will be displayed for five minutes. 17.2 Setting auto-start time This function programs the time the appliance will come on automatically and be ready for use. • Make sure the clock on the appliance is set as described above. • Press the P button then press the button (corresponding to the symbol flashing on the display) repeatedly until the menu arrow is on: START TIME 00:00 • Press the button (corresponding to the SET symbol flashing on the display) to set the auto-start time. (If you hold the button down, the time is changed rapidly.) • Press the OK button to confirm the value. • Press the SET button again and the appliance displays: AUTO-START NO Press the button (corresponding to the SET symbol flashing on the display) to modify the function (the appliance displays: AUTO-START YES) Collection 17